Sprinter NCV3 and VS30 High and Low Roof Air Conditioner Adapter

$205.59
/
Shipping calculated at checkout.
AC Adapter
Which bay you will be installing this in

Suggested Accesories

Sikaflex 221 Adhesive
Dicor Self-Leveling Lap Sealant-10.3 Oz. Tube
Sprinter Interior Framing Support System for Air Conditioner Units
Patent Pending adapter matches the contour of the OEM roof so an air conditioner mounts to a flat surface.  Prevents distorting the roof sheet metal and can be used as an aid for locating the AC. They are CNC machined out of UV and fire resistant expanded PVC.

We highly recommend our interior framing: 

Some of our adapters are made with different size openings than the manuals state. These will be a better fit! 

IMPORTANT:  Please leave a note when putting this in the cart if you are putting one of these in an existing hole that is 14 x 14.

The Nomadic X2/X3 opening is 14 1/4" L x 14 1/2" W

The Mabru opening is 14.675 L x 20.125 W

The Gree opening in our adapter is 12.125" L x 14.125"  W

The OutEquipPro Glacier opening is 14" L x 14" W

The  OutEquipPro Summit opening is 9.35" L x 14.5" W

The Velit 2000R opening is 11.875" L x 15.625" W

The Velit 2000R MINI is 12 1/4" L x 16" W

The Breezonic opening is 15 1/4" L x 15 1/4" W

The Generic Adapter is for AC's not listed that require a 14 x 14 opening.

We highly recommend our interior framing. Please see this listing https://diyvan.com/products/sprinter-interior-framing-support-system-for-air-conditioner-units


If your placement is not centered in the bay, when ordering please give us the following information:

1) Please take a measurement from the center of the large plug on the rear of the van to the back edge of the hole you will cut. Photo of the plug we use is in the main photos.

2) Please let us know what year and what wheel base you have: 144 WB, 170 Regular or 170 Extended.



AC Adapter Install procedure: We recommend Sikaflex 221 or 3m Window-weld adhesive. Locate and cut the hole. You can use the adapter as a guide to mark the hole. Stay clear of roof supports, obviously. Make a tape line 1/4" beyond the adapter perimeter. De-gloss the area with a Scotch- brite pad. No need to scuff. Just dull the paint. Clean with isopropyl alcohol and let dry thoroughly. Blow dryer if it's wet and/or cold out. Apply a good amount of the Window-weld on the face of the adapter. Then press the adapter down onto the roof until the adhesive oozes out the sides. It's not necessary to clamp. If you do, use a lot of lightly set clamps and spread out the clamp force over the whole surface area. Using the adhesive that oozes out, make a fillet around the adapter with a double gloved finger. Pull the tape within 15 minutes. Cure is fast on outside. Let cure overnight and then proceed with the AC install per the AC instruction. Seal the adapter and onto the roof about 1/2" with brush on bed-liner or Flexseal from the TV guy works well. Good idea to check the integrity and reapply the sealant every so often. Dicor self leveling sealant also works but looks a little messy.



DISCLAIMER: Owner and/or installer assumes all risks associated with products and/or components purchased from DIYvan. Owner and/or installer recognizes and agrees that this product, and any of its component parts, is sold “as is” and that DIYvan makes no representation or warranty of merchantability that the product is fit for any particular purpose. 


MORE PRODUCTS