Patent Pending. These adapters solve a unique problem related to fitting a skylight or marine hatch on an Airstream trailer or motorhome. The roof of the Airstream is curved and the skylight or hatch flange is designed to mount and seal against a flat surface. Curvature of the roof can cause leaks and induce uneven stress in the roof which may cause it to deform. Deformation of the roof can cause water to pool along the front and back of the vent which can cause leaks.
The adapter is curved on one side the match the roof and flat on the top to accommodate the flat flange. The adapter adds thickness so screws will hold better than in the thin aluminum.
Each adapter is made specific to the opening and flange size of the skylight or hatch and to the roof curvature. Please send a note with order providing the brand, model and part number of skylight or marine hatch. We will try to get dimensions needed but may need customer to provide measurements of the skylight or hatch. We can recommend skylights or marine hatches that we have used before. We are here to help.
Upon receipt of order we will reach out with instructions on how to easily measure the curvature of the roof. There is a diagram in the listing showing the method. Please make the order and then we will design the adapter. We can send a drawing of the adapter to confirm the measurements provided. If measured properly we guarantee that the adapter will fit.
Adapter Install procedure: We recommend 3m Window-weld or Sikaflex 221 adhesive. Locate and cut the hole. You can use the adapter as a guide to mark the hole. Stay clear of roof supports, obviously. Make a tape line 1/4" beyond the adapter perimeter. De-gloss the area with a Scotch- brite pad. No need to scuff. Just dull the paint. Clean with isopropyl alcohol and let dry thoroughly. Blow dryer if it's wet and/or cold out. Apply a good amount of the Window-weld on the face of the adapter. Then press the adapter down onto the roof until the adhesive oozes out the sides. It's not necessary to clamp. If you do, use a lot of lightly set clamps and spread out the clamp force over the whole surface area. Using the adhesive that oozes out, make a fillet around the adapter with a double gloved finger. Pull the tape within 15 minutes. Cure is fast on outside. Let cure overnight and then proceed with the hatch install per the hatch instruction. Seal the adapter and onto the roof about 1/2" with Dicor self leveling sealant or Flexseal from the TV guy works well. Good idea to check the integrity and reapply the sealant every so often.
DISCLAIMER: Owner and/or installer assumes all risks associated with products and/or components purchased from DIYvan. Owner and/or installer recognizes and agrees that this product, and any of its component parts, is sold “as is” and that DIYvan makes no representation or warranty of merchantability that the product is fit for any particular purpose.