Set of 4 hub covers. 2 for the front wheels and 2 for the back wheels.
These hub plates stick out much less than the OEM hub caps on Transit AWD vans. Machined from 6mm (1/4") ABS plastic and attached to the wheel with VHB tape. Front ones are discs and the rear ones are rings. They install under lug nuts so can not fall off. All lug nuts must be removed to install. Be sure to jack up and safely support each axle during installation and re-torque lug nuts to proper spec. Photos show painted wheel studs and lug nuts. This can be done with a small brush and paint (not included) after installing the plates. Does not interfere with removal of wheel.
Installation tips.
Make sure to work in warm temperature or lightly heat wheel and double sided tape with heat gun on low setting or blow drier.
Jack up and support axle.
Remove lug nuts but leave wheel in place.
Clean surface of wheel with isopropyl alcohol.
Remove VHB backing on hub cover.
Place hub cover on wheel but do not let double sided tape stick to wheel.
Locate hub cover by installing and lightly tightening two lug nuts across from each other.
Press plate firmly against wheel so double sided tape adheres.
Install remaining lug nuts and torque to factory specs.
For best adhesion allow VHB to set 12-24 hours before driving vehicle. Additional heating will also help improve bond.
Please contact Hein at 54l 49O 5O98 for technical assistance.
DISCLAIMER: Owner and/or installer assumes all risks associated with products and/or components purchased from DIYvan. Owner and/or installer recognizes and agrees that this product, and any of its component parts, is sold “as is” and that DIYvan makes no representation or warranty of merchantability that the product is fit for any particular purpose.